|
Installing Slatwall Panels
We recommend professional installation of Slatwall Panels, by a licensed and insured Commercial Contractor. However, if you chose to install panels yourself, following are some
helpful tips.
Always consult your local and regional building codes and obtain the proper permits to install slatwall panels.
Preparation
Slatwall Panels are typically installed with 2 1/2" to 3" long screws into the wall studs.
First, determine the type of wall stud material you are applying the slatwall panels to.
For wood studs, you will need Coarse thread screws, for extra holding power. Use self-tapping (self drilling) screws for installation to metal studs.
Always level each Slatwall panel before installation.
|
|
|
|
|
For Wood Studs
|
For Metal Studs
|
Cutting Slatwall Panels
Slatwall panels can be cut very easily. For straight cuts use a table saw and cut the panel face
UP, or use a circular saw and cut the slatwall panel face DOWN. Use a sharp blade with
60-80 teeth.
For irregular shaped cuts in slatwall panels, use a jig saw with a medium blade, approximatly 10 teeth per inch.
Slatwall Installation
Drill screws THROUGH the Slatwall grooves INTO the studs. It will be necessary to locate and
mark the lateral position of the wall studs prior to installation. Wherever possible, vertical panel seams should end on a wall stud.
Use a minimum of 24 screws, spaced evenly over each slatwall panel. For a more permanent installation,
also use a general purpose panel adhesive, applied to the back of each slatwall panel.
If your slatwall panel has aluminum extrusions (groove inserts), use 2 1/2" to 3", #6 or
larger screws. It will be necessary to first pre-drill a pilot hole through the
aluminum groove insert.
Masonry Walls
|
Masonry walls should first be framed with wood studs, to meet local building codes. Then slatwall
panels can be attached directly to the newly installed wood studs.
|
|
|
