Store Fixtures Supply | Gridwall | Slatwall

01-016OR - Z Backroom Rack
1. Attach each Z end piece to bottom frame, using provided 2 screws per end piece.
2. Insert rubber bumper onto each wheel's bolt.
3. Attach each wheel/bumper to frame using 1 lock washer and 1 lock nut.
4. Insert each side upright into frame.
5. Attach top hangrail to uprights.

01-009CH - Rolling Rack
1. Remove screws from ends of 47" base cross pieces with allen wrench (supplied).
2. Attach cross pieces to uprights, with height adjustment holes facing inward,
using screws from #1.
3. Remove screws from ends of 31" height adjustment bars.
4. Attach height adjustment bars to hangrail, with height push pins facing inward,
using screws from #3.
5. Insert hangrail with height adjustment bars into uprights at desired height.

01-010CH - Collapsible Rolling Rack
1. Unfold rack.
2. Attach hangrail to uprights.
3. Remove (2) Screws from base frame and use to attach hangrail clamps.

00-001CH, 00-004CH - Round Racks
1. Insert (4) footed legs into frame at desired height.
2. Unfold frame and stand rack up.
3. Attach top ring by aligning holes with hold tabs.
4. Optional: Insert (4) shelf rests into frame crossbars.

08-006CH - Spiral Rack
1. Remove screw and lockwasher from end of center base pole.
2. Attach center base pole to base using screw, lockwasher,
and metal spacer from under base bottom.
3. Fit top pole over bottom pole.
4. Attach spiral support arms to spiral piece with mounting rings facing inward.
5. Attach spiral assembly to top pole at desired height and tighten screws.

02-010CH, 02-011CH, 02-012CH, 02-013CH
Arm Racks
1. Remove bolts and washers from center upright.
2. Insert base weight into chrome base cover and chrome plate between base and upright.
3. Attach base to upright with bolts and washers from step #1.
4. Insert arms into upright at desired height.

04-004CH, 04-008CH, 04-005CH, 04-006CH,
Arm Racks
1. Remove 4 hex bolts from ends of base legs and uprights.
2. With rack upright arm adjustment holes facing inward, attach 2 legs to uprights with bolts from step #1, in a pinwheel shape.
3. Remove 2 bolts from ends of upper support arm.
4. Attach upper support arm using bolts from step #3.
5. Insert arms at desired height.

© Copyright 2004 Store Fixtures Supply.
All content included on this site, such as text, graphics, logos, button icons, images, and software
is the exclusive property of Store Fixtures Supply and is protected by United States and International Copyright laws. All rights reserved.
Use of this website is subject to certain terms and conditions of use which constitute a legal agreement between you and This Site.